Timing Belt Pulley LR 6 3/8" BORE
Part. N° 28.9510
| APPLICATIONS |
| - Timing belt reverse unit for LR6 linear rail & slides & a motor with a Ø3/8" shaft with flat |
| - 3/8" shafts are most commonly found on Nema 23 & Nema 34 Motors |
| - Light & medium duty linear motion |
| -Additional machining to pulley housing and/or an adaptor plate are required to mount motor directly to pulley housing. Send motor print to sales@minitecframing.com for technical assistance. |
| TECHN. DATA / ITEMS SUPPLIED |
| - Aluminum housing, Powder coated gray |
| - 16AT5 aluminum pulley, 36 teeth |
| - Qty 2, Ball Bearings |
| - Qty 1, M5x5 Set Screw with thread lock |
| - Qty 4, M8x20 C' sunk screws & M8 nuts |
| - Bore Dia. |
- .375" No key |
| - Re-borable to: |
- 14mm |
| - Travel (1 Rev) |
- 180mm |
| - Frictional moment at 1/1000 belt tensioning |
- .30 Nm |
| - Max load |
- 30 Nm |
| - Weight |
- .94 Kg. |
| ASSEMBLY |
| - Insert supplied M8 square nuts into rail |
| - Feed timing belt thru pulley |
| - Move pulley over rail & join supplied M8x20 C' sunk screws with square nuts (Don't tighten yet) |
| - Fix timing belt on slide |
| - Tension belt thru access holes in back See Picture |
| - Tighten M8x20 C' sunk screws |
| - Line up set screw in pulley with access hole in pulley housing |
| -Insert motor shaft with flat facing set screw |
| - Tighten set screw against shaft using a 2.5mm hex key |
| - Belt length in reverse unit = 160mm |
| - Timing belt length = 2xRail Length + 260mm |
